Installing Accessories
Hard Disk Drive Cage
Chapter 2 19
Hard Disk Drive Cage
Opening the Hard Disk Drive Cage
To open the cage (Figure 2-3):
1. Disconnect the SCSI cable(s) and power cable(s) from the hard disk
drive(s).
CAUTION Do not rotate the cage before you disconnect the cables.
2. Remove and retain the two Torx screws that hold the cage closed as
shown in Figure 2-3.
3. Pull the cage toward you until you hear the hard disk drive cage clip
catch the cage.
WARNING Make sure the clip has latched the cage in the open position.
An injury could result if the cage falls.
To Next Page
Loading...
