Installing Accessories
Hard Disk Drive Cage
Chapter 220
Figure 2-3 Hard Disk Drive Cage
Closing and Securing the Hard Disk Drive Cage
CAUTION Clear all cables from the area where the hard disk drive cage rests on the
chassis beam assembly. If cables are in the way, you may damage them
when you move the hard disk drive cage back into the closed position.
To close and secure the hard disk drive cage:
1. Push in the clip shown in Figure 2-3 on page 20 and rotate the hard
drive cage carefully into the closed position.
CAUTION Do not allow the cage to drop into place. This could damage the hard
drive(s).
2. Fasten the cage with two screws in the locations shown in Figure 2-3
on page 20.
Step 2
Upper Bay
Lower Bay
Hard Disk
Drive Cage
Clip
Screws for
installing a
second
hard disk
drive
To Next Page
Loading...
