Installing Accessories
Hard Disk Drive Cage
Chapter 2 21
3. If it is not already attached, connect the SCSI cable to the system
board internal SCSI connector as shown in Figure 2-4.
Figure 2-4 Internal SCSI Connector and Cable
4. Connect the SCSI cable to the hard disk drive(s):
a. Attach the SCSI connector farthest from the system board to the
hard drive in the upper bay.
b. Attach the remaining SCSI connector to the hard drive in the
lower bay.
5. Connect the power supply cable(s) to the hard disk drive(s):
a. Connect the power supply cable labeled P3 to the hard disk drive
in the upper bay.
b. Attach the power supply cable labeled P4 to the hard disk drive in
the lower bay.
SCSI cable
connected to
internal SCSI
Connector
External SCSI
connector
To Next Page
Loading...
