Setting Up and Using Your Linux Workstation
Setting Up Your Linux Workstation
Chapter 1 13
Connect the Components
Before connecting any cords or cables to your Workstation, please read
“Important Safety Information” on page 9.
Figure 1-1 on page 14 shows the back panel of the Workstation. When
you connect the components, match the color-codes of the connectors. The
connectors are shaped to go in one way only.
1. Connect the mouse.
2. Connect the monitor to the 15-pin display connector and tighten the
attachment screws.
3. Connect the three HP Multimedia Keyboard cables:
• The keyboard connector plugs into the purple connection.
• The pink microphone connector plugs into the microphone jack.
• The lime green headphone connector plugs into the output line
jack. Don’t plug this connector in if you don’t have speakers!
NOTE The internal speaker is deactivated after you connect the multimedia
keyboard output line jack. Therefore, if you connect the keyboard’s
headphone connector to the back of the Workstation, you must plug
speakers or headphones in to the back of the multimedia keyboard to
get audio as explained in “Connect the Audio Accessories” on page 15.
4. If you have a printer, connect your printer cable and tighten the
attachment screws.
5. If you have any serial devices, connect them to serial port A or B.
To Next Page
Loading...
