Setting Up and Using Your Linux Workstation
Setting Up Your Linux Workstation
Chapter 1 15
Connect the Audio Accessories
Connect the microphone and headphones (or amplified speakers) to the
HP Multimedia keyboard as shown in Figure 1-2.
WARNING Listening to loud sounds for prolonged periods of time may
permanently damage your hearing.
NOTE The internal speaker is deactivated when you use the output line jack on
the rear of the Workstation. If you have connected the keyboard
headphones connector to this jack, you must connect speakers or
headphones to the keyboard for audio output.
Figure 1-2 Connecting Audio Accessories
Connect to a Network (LAN)
Your Workstation’s 10BT/100TX LAN auto-sensing interface adapter
supports both 10Mbit/s and 100 Mbit/s operation.
Connect the network cable to the LAN connector shown in Figure 1-1 on
page 14.
Keyboard headphones/
speaker socket
Keyboard microphone
socket
To Next Page
Loading...
