Setting Up and Using Your Linux Workstation
Using Your x4000 Linux Workstation
Chapter 118
• Hard Disk Activity LED — This light flickers when your hard disk is
being accessed.
• Network Activity LED — This light flickers anytime the workstation
is connected to the network and plugged into the power source,
regardless of whether the workstation is turned on.
• Diag LEDs — These four LEDs can be off, green, yellow, or red. The
color pattern lets you diagnose problems with your Workstation. For
more information, see “Understanding the Diag LEDs” on page 52.
Starting and Stopping Your Linux Workstation
Starting Your Workstation for the First Time
Your Linux Workstation has pre-installed Red Hat Linux and HP
software. It is initialized the first time you start the Workstation. The
software initialization process takes a few minutes. Upon start-up, you
will see the screen depicted below. Fill-in the information requested.
For more information on system start-up, configuration and recovery see
the chapter “Linux System Setup and Recovery”.
To Next Page
Loading...
