Setting Up and Using Your Linux Workstation
Using Your x4000 Linux Workstation
Chapter 1 17
Using Your x4000 Linux Workstation
Understanding the Control Panel
The hardware control panel, located on the front of the Workstation, is
shown in Figure 1-3.
Figure 1-3 Hardware Control Panel
• Power On/Off button: Press this button to start the Workstation. You
can also wake the Workstation from Hibernate or Stand By mode by
pressing this button for less than four seconds. Press this button for
more than four seconds to turn the Workstation off.
• Power LED:
— Solid green indicates system on.
— Solid yellow indicates the Workstation is in Stand By or Hibernate
mode.
— Flashing yellow, flashing red, or solid red indicates a system error.
See “Understanding the Diag LEDs” on page 52.
• Reset button: Press this button to re-initialize all the hardware
without cycling power to the system (soft boot). Avoid general use of
this button because file damage may occur. Always use the operating
system Shut Down command before resetting the machine.
Power On/Off
and Power LED
Hard Disk
Activity LED
Reset Button
Network
Activity LED
Diagnostic LEDs
To Next Page
Loading...
