HP Workstation z400

7 Installing memory
This section describes how to add memory to your workstation.
Supported memory configurations
The following table describes the memory configurations supported by the HP Workstation series.
400 600 800
Installation guidelines
●
Install only HP- approved, unbuffered, DDR3 DIMMs.
●
Refer to the quick specs at
http://www.hp.com/go/productbulletin for specific DIMM compatibility
information for HP workstations.
Supported configurations
●
Four DIMM slots
●
Memory configuration from
1 GB to 16 GB
Supported configurations
●
Six DIMM slots
●
Memory configuration from
1 GB to 24 GB
Supported configurations
●
Twelve DIMM slots
●
Memory configuration from
1 GB to 96 GB
NOTE: For memory
configurations greater than
92 GB the 1110W power
supply is required.
DIMM installation order DIMM installation order
Single processor:
Dual processor:
DIMM installation order
Single processor:
Dual processor:
ENWW Supported memory configurations 43