HP xw4200 - Page 41

Access Time (typical reads,
including settling)
Random DVD < 140 ms (typical)
Random CD < 125 ms, (typical)
Full Stroke DVD < 250 ms (seek)
Full Stroke CD < 210 ms (seek)
Startup Time (single) < 7 seconds (typical)
Startup Time (multi-session) < 30 seconds (typical)
Stop Timex < 4 seconds
Cache Buffer 2 MB (minimum)
Data Transfer Modes ATA PIO mode 4 (16.7 MB/s); ATA Multi-word DMA
mode 2 (16.7 MB/s); ATA UltraDMA Mode 2 33
Mbytes/s (default)
Power Source Four-pin, DC power receptacle
DC Power Requirement 5 VDC ± 5%-100 mV ripple p-p
12 VDC ± 10%-200 mV ripple p-p
DC Current 5 VDC (< 2000 mA typical, < 2500 mA maximum)
12 VDC (< 700 mA typical, < 2000 mA maximum)
Total Drive Power
(standby mode)
< 2.5 Watt
Audio Output Line-Out 0.7 VRMS
Signal-to-Noise Ratio 75 dB
Channel Separation 55 dB
Operating Environmental
(all conditions non-
condensing)
Temperature 41° to 122° F (5° to 50° C)
Relative humidity 10% to 90%
Maximum wet bulb
temperature
86° F (30° C)
System Configuration Intel® Pentium® III Processor or later with 128 MB of memory (required); 256 MB
recommended 2-D or 3-D graphics cards on primary disk drive for operating system
and application software; second disk drive for audio and video data
Operating Systems
Support
Microsoft® Windows® 2000, Windows XP Professional, Windows XP Home
Regulatory Approvals MPC-3 compliant, multi-read requirements, ATA Spec X3T9.2, ATAPI Spec T13.1153D,
ANSI C63.4-1992, UL 1950, ACA AS/NZS 3548, CB Bulletin No. 96A, CSA C22.2 No.
950-1995, CFR 47 C.I.S.P.R. Pub 22 Class B, DHHS/FDA, EMKO-TSE 07/94, TUV
EN60950, EN60825-1, MIC, BSMI-CNS 13438, CE, Microsoft® PC2001 certification,
Microsoft Logo for Windows® XP and 2000.
Option Kit contents DVD+R/+RW Drive, InterVideo WinDVD, InterVideo WinDVD Creator, Roxio Easy CD
Creator, Dantz Retrospect Express Backup Software, installation guide, and DVD+R
media.
QuickSpecs
HP Workstation xw4200
Technical Specifications - Optical Devices
DA - 12022 Worldwide — Version 6 — September 1, 2004 Page 41