6
8. Replace the side access panel:
a. Lower the access panel onto the chassis (aligning the guide rail on the bottom inside edge of the
access panel with the bottom edge of the workstation chassis).
b. Close the access panel, ensuring that the guides on the top of the access panel slide into the rails
at the top of the chassis.
9. If desired, lock the access panel using the key provided.
Attach Rack Mounting Brackets to Workstation Chassis
1. Lay the workstation on its side with the top of the chassis on your right and the bottom on your left.
2. Attach the left bracket:
a. Align the left bracket with the screw holes on the left side (bottom) of the chassis.
b. Use a Phillips screwdriver and two M4 flathead screws to attach the bracket.
c. Attach the right bracket using the same procedure.
Align guide rail with bottom edge of chassis
Left bracket
Right bracket
To Next Page
Loading...
