HP xw8200

Supplied Software None
16X/48X DVD-ROM
Drive with +R Read
Support
Height 5.25-in, half-height, tray load
Interface Type ATAPI/EIDE
Dimensions (W x H x D) 5.88 x 1.71 x 7.87 [max] in (149.5 x 43.25 x 200.0 [max] mm) (external,
excluding bezel)
Disc Formats DVD-ROM (single and dual layer); DVD-video; DVD-R version 1.0 and
2.0; DVD-RW version 1.0 and 1.1; DVD-R multi-border; DVD+RW;
DVD+R ; CD-ROM Mode 1 and 2; CD-DA; CD-ROM XA Mode 2, Form
1 and 2; CD-extra; CD-text; CD-I Mode 2, Form 1 and 2; CD-I ready;
video CD, CD-bridge; PhotoCD (single and multi-session); CD-R; CD-
RW
Disc Capacity DVD-ROM 4.7 GB (DVD-5), 8.54 GB (DVD-9), 9.4 GB
(DVD-10), 3.95 GB (DVD-R version 1.0), 4.7
GB (DVD-R version 2.0), 4.7 GB (DVD-RW
version 1.0 and 1.1), 4.7 GB (DVD+RW),
4.7G (DVD+R)
CD-ROM 540 MB (Mode 1, 12 cm), 640 MB (Mode 2,
12 cm), 700 MB (80 minimum CD-R and CD-
RW), 180 MB (8 cm)
Access Times
(typical reads, including
settling)
DVD-ROM Single Layer 120 ms
CD-ROM Mode 1 90 ms
Full Stroke DVD 240 ms (seek)
Full Stroke CD 160 ms (seek)
Startup Time < 10 seconds (typical)
Stop Time < 4 seconds
Data Transfer Modes PIO Mode 4 (16.6 MB/s); Multi-word DMA
mode 2 (16.6 MB/s); UltraDMA Mode 3 (44.4
MB/s)
Maximum Data
Transfer Rates
CD-ROM Read 6000 KB/s (40X) Max
DVD-ROM Read 21,600 KB/s (16X) Max
Digital Audio
Extraction
6000 KB/s (40X) Max
Power Source Four-pin, DC power receptacle
DC Power Requirement 5 VDC ± 5% – 100 mV ripple p-p
12 VDC ± 5% – 200 mV ripple p-p
DC Current 5 VDC – <800 mA typical,
< 1000 mA maximum
12 VDC – < 870 mA typical,
<1800 mA maximum
Audio Output Line-Out 0.7 VRMS
Signal-to-Noise Ratio 85 dB
Channel Separation 65 dB
Configuration Jumper
Block
Master, slave, and cable select modes
Data Interface
Connector
40-pin, shrouded and keyed, flat ribbon
QuickSpecs
HP xw8200 Workstation
Technical Specifications - Optical Devices
DA - 11976 Worldwide QuickSpecs — Version 42 — 5.25.2007 Page 43