HP XW8400

1/12
SAS rear panel cable installation
SAS Rear panel cable installation
HP xw series workstations
This document describes how to install the Serial Attached SCSI (SAS) rear panel cable to your HP
workstation.
Kit contents
This kit includes the following components:
■ SAS rear panel cable with mounting screw
■ SAS rear panel mounting bracket
■ External SAS label
■ SAS rear panel cable instruction (this document)
■ Warranty
Before you begin
See http://www.hp.com/accessories/workstations to determine the compatibility of this product with your
HP workstation.
Observe warnings and cautions
Å
WARNING: Any surface or area of the equipment marked with these symbols indicates the presence of
a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the
risk of injury from a hot component, allow the surface to cool before touching.
Å
WARNING: Any surface or area of the equipment marked with these symbols indicates the presence of
an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed
area.