2/12
SAS rear panel cable installation
Å
WARNING: To reduce the risk of electric shock or damage to your equipment:
❏ Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
❏ Plug the power cord in a grounded (earthed) outlet that is easily accessible at all times.
❏ Disconnect power from the equipment by unplugging the power cord from the electrical outlet.
Å
WARNING: To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper
workstation, setup, posture, and health and work habits for computer users, and provides important
electrical and mechanical safety information. This guide is located on the Web at
http://www.hp.com/ergo and/or on the documentation CD if one is included with the product.
Ä
CAUTION: Static electricity can damage the electronic components of the workstation. Before beginning
these procedures, be sure you are discharged of static electricity by briefly touching a grounded metal
object.
✎
NOTE: HP accessories are for use in HP workstation products. They have been extensively tested for
reliability and are manufactured to high quality standards. HP, therefore, warrants only those accessories
that are manufactured or sold by HP.
Step 1—Prepare the workstation
Your workstation documentation includes instructions for disassembling and preparing the workstation for
installation, including shutting down power, disconnecting all power from the system, and removing the
access panel.
For more detailed information, refer to the Service and Technical Reference Guide for your HP
Workstation at
http://www.hp.com/support/workstation_manuals.
To Next Page
Loading...
Need help?
General
