2. Remove the screw attaching the lock to the chassis as shown in the following figure.
Figure 4-5 Removing the lock screws
Side access panel
Before accessing the internal components of the workstation, you must remove the side access panel.
This section describes how to remove and replace the side access panel.
Removing the side access panel
To remove the side access panel:
WARNING! Before removing the workstation side access panel, be sure that the workstation is
powered off and that the power cord is disconnected from the electrical outlet.
1. Disconnect power from the system (see Predisassembly procedures on page 52).
2. Unlock locks that are present (such as security lock, cable lock, or universal chassis clamp lock).
ENWW Removing and replacing components 57
To Next Page
Loading...
