3. Pull up on the handle and rotate the cover off the chassis as shown in the following figure.
Figure 4-6 Removing the access panel
Replacing the side access panel
To replace the side access panel:
1. Align the bottom groove of the side panel with the bottom edge of the chassis.
2. Rotate the side panel toward the chassis and press firmly until the latch engages.
Hood Sensor (Smart Cover Sensor) (optional)
This section describes how to remove the Hood Sensor.
Removing the Hood Sensor
To remove the Hood Sensor:
1. Disconnect power from the system (see
Predisassembly procedures on page 52).
2. Remove the side access panel (see
Removing the side access panel on page 57).
3. Disconnect the hood sensor connector from the inline connector attached to the front panel
harness.
58 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
