HP Z Turbo Drive Quad Pro - Installing in HP Z640 Workstation

5. Press the two green PCI retention clamp tabs on the rear of the chassis up until they lock into place.
Installing the drive in an HP Z640 Workstation
If more than one of any of the following drives are to be installed in a system, a unique address for each drive
must be congured before installation:
●
HP Z Turbo Drive
●
HP Z Turbo Drive G2
●
HP Z Turbo Quad Pro
For conguration instructions, see Installing multiple HP Z Turbo Drives or HP Z Turbo Quad Pro Drives
on page 14.
1. Press down on the two green PCI retention clips located on the rear of the chassis (1) until they release,
then rotate the clips down to raise the retention clamp from the slot covers (2).
10 HP Z Turbo Drive Quad Pro installation