To Next PageTo Next Page
Need help?Do you have a question about the HP Smart Array B140i and is the answer not in the manual?
General| Controller Model | HP Smart Array B140i |
|---|---|
| Interface | SATA |
| Number of Ports | 6 |
| Maximum Drives Supported | 6 |
| RAID Levels | 0, 1, 10 |
| Compatibility | HP ProLiant Gen8 Servers |
| Form Factor | Embedded |
Provides a detailed description of the HPE Dynamic Smart Array B140i RAID controller's features and architecture.
Explains how to set the system's boot mode between UEFI and Legacy BIOS for controller compatibility.
Details the steps required to enable the HPE Dynamic Smart Array B140i controller in the system's BIOS/RBSU.
Guides users on setting up storage arrays using RAID methods for optimal performance and fault tolerance.
Methods to identify a failed hard drive using LED indicators and system messages.
Procedures to attempt data recovery and restore logical volumes when fault tolerance is compromised.
Step-by-step instructions for safely replacing failed hard drives in various RAID configurations.
Details the automatic data recovery process (rebuild) after a drive replacement.
Diagnoses and provides solutions for scenarios where the drive rebuild process fails to complete successfully.
Instructions on how to add new hard drives to a system and create new arrays.
Introduction to HPE SSA, the primary tool for configuring and managing Smart Array controllers.
Overview of Intelligent Provisioning, a tool for simplifying server deployment and OS installation.
Lists and describes various diagnostic tools available for troubleshooting array problems.
Precautions to take to prevent damage to the system from electrostatic discharge (ESD).
