HP Smart Array B140i User Manual

Overview 5
Overview
About the HPE Dynamic Smart Array B140i RAID
controller
The HPE Dynamic Smart Array B140i RAID controller is a RAID solution combining SATA ports and
proprietary software components. Eliminating most of the hardware RAID controller components, and
relocating advanced RAID algorithms from a hardware-based controller into device driver software lowers
the total solution cost, while still maintaining comparable RAID protection and full compatibility with Smart
Array disk format, configuration utilities, and management/monitoring software.
The Dynamic Smart Array controllers share the same easy and consistent UI with standup Smart Array
controllers, thus making storage management and deployment easier for IT workers.
Features
The B140i controller has the following features:
• RAID 0, 1, 10, 5
• Maximum drives supported—10
• Maximum LUNs supported—10
• Active Health Support
• iLO Management support
• Drive temperature reporting via iLO
• HPE SSA support
• UEFI BIOS
• Smart Carrier support ("Drive LEDs" on page 15)
• Hot-plug and non-hot-plug configurations
• SATA hard drive, SATA SSD, and SATA M.2 drive support
• Work load logging
• SSD Wear Gauge
• SMART
• Drive rebuild
• Online spares
• Predictive spare activation
I
MPORTANT: The Dynamic Smart Array B140i Controller supports UEFI Boot Mode only. It
does not support Legacy BIOS Boot Mode.
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).

HP Smart Array B140i Specifications

General

Brand	HP
Model	Smart Array B140i
Category	Computer Hardware
Language	English