Replacing, moving, or adding hard drives 22
3.
In the Storage Controller section, verify that the system recognizes the Smart Array controller.
4. Power down the server.
5. Remove the access panel.
6. Remove components and cables as needed.
7. Disconnect the existing data cable from the hard drive backplane.
8. Connect the SAS cable to the controller and hard drive backplane.
This action replaces the SATA connection.
9. Install components and cables removed previously.
10. Install the access panel.
a. Power up the server.
Migrating drives to an optional host bus adapter
For information on installing an optional host bus adapter and migrating the drives, see the appropriate
host bus adapter user guide on the Hewlett Packard Enterprise website
(http://www.hpe.com/info/smartstorage/docs).
To Next Page
Loading...
