Table 1-1 Product information (continued)
Topic Location
HP Cool Tools (Windows® 7
only)
Most HP workstations with the Windows 7 operating system are preloaded with
tools that may enhance system performance and with additional software that is not
automatically installed during first boot. To access these applications:
●
Click the HP Cool Tools icon on the desktop, or
●
Open the HP Cool Tools folder by selecting Start > All Programs > HP > HP
Cool Tools.
To learn more about these applications, click HP Cool Tools—Learn More.
To install or launch the applications, click the appropriate application icon.
Additional information is located in the
Maintenance and Service Guide
for your
workstation on the web at
http://www.hp.com/support/workstation_manuals/.
Regulatory information Refer to the
Safety & Regulatory Information
guide for product regulatory
information. You can also refer to the regulatory label on the workstation chassis.
Accessories For complete and current information on supported accessories and components,
see
http://www.hp.com/go/workstations.
System board A diagram of the system board is located on the inside of the side access panel
(tower and desktop configurations) or on the inside of the chassis (all-in-one
configurations). Additional information is located in the
Maintenance and Service
Guide
for your workstation on the web at http://www.hp.com/support/
workstation_manuals/.
Serial number, Certificate of
Authenticity (COA) labels, and
Genuine Microsoft Label (GML)
(if applicable)
Serial number labels are on the top or back panel (tower and desktop
configurations). The COA (Windows 7) label and GML (Windows 8) are typically
located near the serial number label. Some workstations have this label on the
bottom panel.
Linux For information on running Linux on HP workstations, go to
http://www.hp.com/
linux/, then select Linux on Workstations from the list on the left.
2 Chapter 1 Locating HP resources
To Next Page
Loading...
Need help?
General
