EasyManuals Logo

HPI Racing Powerful G3.0 Engine User Manual

HPI Racing Powerful G3.0 Engine
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
3
Engine Start Starten des Motors marrage du moteur ンの始動
Attach the glow igniter to the glow plug. Start the engine by pulling the starter cord in short pulls. Remove the glow igniter as soon as the engine is running.
Stecken Sie den Glühkerzenstecker auf die Glühkerze. Starten Sie den Motor, indem Sie kurz das Startseil ziehen. Ziehen Sie den Glühkerzenstecker ab, sobald der Motor läuft.
Fixez le chauffe-bougie sur la bougie. Démarrez le moteur en tirant le lanceur par petits coups. Retirez le chauffe-bougies que le moteur commence à tourner.
ローププラグヒターをけプルスターターを数回引きエを始動す。ンが始動ーターを取ます。
Glow Plug Igniter
Glühkerzenstecker
Chauffe-bougies
プラグヒータ
Exhaust Pipe
Resonanz-Rohr
Pot d’échappement
フラ
Pull Starter
Seilzugstarter
Lanceur
プルスーター
2
1
Glow Plug
Glühkerze
Bougie
ロープ
If Engine Does Not Start Falls der Motor nicht startet Si le moteur ne marre pas が始動ないきは
If there is too much fuel in the cylinder, the engine will not start.
Follow the step below to remove excess fuel from the cylinder. Remove the glow plug
and pull the starter cord several times to remove excess fuel. Reinstall the glow plug .
Falls zuviel Kraftstoff im Zylinder ist, kann der Motor nicht starten.
Folgen Sie den unten aufgeführten Schritten, um den überflüssigen Kraftstoff zu
entfernen.Entfernen Sie die Glühkerze und ziehen Sie ein paar Mal am Seilzugstarter
um den überflüssigen Kraftstoff zu entfernen. Montieren Sie anschließend wieder die
Glühkerze.
S’il y a trop de carburant dans le cylindre, le moteur nemarrera pas.
Suivez l’étape ci-dessous pour retirer le carburant en excès du cylindre. Retirez la
bougie et tirez le lanceur plusieurs fois pour retirer l’excédent de carburant.
Remettez la bougie.
燃料をすぎ内に燃料があふれ、エンジンの始動ができます。
次の手順でエ内の燃料を取除いてださい。グロープラグを取プルスターターを数回引き
ン内にあふれた燃料を抜きます。燃料が抜けた後、再びグロープを取付けます。
87546
Glow Plug Wrench
Glühkerzenschlüssel
Clé à bougies
ロープ
Glow Plug
Glühkerze
Bougie
ロープ
8
mm
12”
30cm
MAX
Never pull the starter cord more than 30cm (12").
Ziehen Sie den Seilzugstarter niemals weiter als 30cm (12").
Ne tirez jamais le lanceur de plus de 30 cm (12 pouces)
プルスーターは30cm以上引かないでさい。

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPI Racing Powerful G3.0 Engine and is the answer not in the manual?

HPI Racing Powerful G3.0 Engine Specifications

General IconGeneral
BrandHPI Racing
ModelPowerful G3.0 Engine
CategoryEngine
LanguageEnglish

Related product manuals