What to do if HQUA HQUA-PN01 does not light up at the beginning?
If your HQUA Swimming Pool Lighting doesn't light up initially, there could be several reasons. First, ensure the receptacle has power. Second, verify the wiring connections are correct, paying attention to wire colors. Finally, if neither of these resolves the issue, the LED pool light may be damaged, and you should contact HQUA for assistance.
What to do if HQUA HQUA-PN01 does not light up after a few time using?
If your HQUA Swimming Pool Lighting stops working after some time, the issue might be a loose power cord. Make sure to check the wiring connections, but be sure to cut off the power supply first. If the GFCI is tripped, contact HQUA for further assistance.
Why is there water inside my HQUA HQUA-PN01 Swimming Pool Lighting?
If you notice water inside your HQUA Swimming Pool Lighting, there's no need to worry. This is acceptable and safe. The special waterproof material used will protect the light.
Covers electrical hazards, grounding, GFCI, and safe electrical practices.
Lists warnings about staring at the light, water exposure, and general handling.
Details the weatherproof transformer and LED light assembly.
Lists technical specs like wattage, voltage, luminous flux, and color.
Provides step-by-step instructions for installing the pool light.
General| Model | HQUA-PN01 |
|---|---|
| Category | Swimming Pool Lighting |
| Power | 18W |
| Voltage | AC12V |
| IP Rating | IP68 |
| Beam Angle | 120 degrees |
| Lifespan | 50, 000 hours |
| Light Source | LED |
| Type | Underwater Light |
To Next Page
