HSC ELITE - INSTALLATION AND OPERATION; Connecting Gas Cylinder and Heater; Igniting, Operating, and Turning Off; Gas Leak Detection

GASCABINETHEATER USER MANUAL
3
INSTALLATION:
1. Locate the gas cylinder into the gas heater by accessing from the rear.
2. Install the bottle retaining plate to ensure the cylinder is secure in position.
3. Connect the gas hose and gas valve to the cylinder (make sure there is no gas leak)
4. Open the gas tap before using the heater, and close the gas tap after using.
Before connecting the regulator to the gas cylinder. Check whether there is a
rubber washer on the regulator, and the washer must be in good condition.
IGNITING HEATER:
Connect the regulator to the gas cylinder by turning the hand wheel anticlockwise. Open the gas cylinder
by turning the gas cylinder valve anticlockwise.
Turn the gas control knob on the heater to setting I (g1).
Press the control knob down and hold in the pressed condition. This will allow gas to ow to the pilot and
center burner.
While holding the control knob in the pressed position push the piezoelectric ignition (g1) button 2 or
3 times. Each time you strike this piezoelectric ignition you will hear a clicking sound as well as see a spark
on the pilot burner.
Once the pilot has lit, continue holding the gas control knob in the pressed position for a further 15
seconds thus activating the ame failure safety device and ensuring the appliance remains lit.
The pilot and center burner should remain alight. You may now adjust the heater setting to
Low/Med/High as required.
TURNING OFF THE HEATER:
To turn off the heater, turn the control knob to position 1 and close the gas cylinder
valve by turning the knob on the cylinder clockwise.
Ensure that the pilot ame and the center burner are extinguished.
TESTING GAS LEAKS:
If you suspect that the heater is leaking, turn off the gas supply and have
the unit inspected by a qualied technician.
Do not attempt to locate the source of leak with a naked flame.
Locate it by sound, smell or by applying soapy water. Any bubbles forming will
indicate the whereabouts of a leak.
In the event of leakage, the appliance should be turned off at the regulator and
disconnected from the cylinder.