To Next Page
R
Regina MartinAug 6, 2025
What to do if the HSM Power Tool baler malfunctions and a red light is displayed?
- JJason TranAug 6, 2025
If the HSM Power Tool baler malfunctions and displays a red light, it could be due to several reasons. It may be caused by a missing phase, incorrect connection of phases, or the wrong direction of rotation. In these cases, it is recommended to have an electrician check the onsite fuses and rotatory field. Alternatively, the oil temperature might be too high, in which case you should let the oil cool down. A defective sensing device for oil temperature could also be the cause, which would require an electrician to change the sensing device. In case the motor protective switch, door switch, or the limit switch for 'Press ram on top' is defective, contact the HSM service.
General
