12/2014 SECURIO B 32 13
english
5 Operation
WARNING
Before switching the machine on,
make sure that you observe all
safety instructions.
Shredding CDs
(only in cut size: 5.8 mm, 3.9 mm, 4.5x30 mm)
• Only feed the material
into the insertion slot
of the safety element
(splinter protection).
Note:
To completely separate
the materials shredded,
you can insert the CD
bag supplied.
Switching on the shredder
• Connect the power plug of the machine
into a properly installed socket.
•
Set mains switch at rear of paper shredder
to „I“.
• Press the operation button.
The “Ready for operation” indicator lights
up.
Shredding paper
• When you feed paper, the light barrier
automatically starts the cutting unit.
Two seconds after the light barrier in the
paper feed opening is free again, the cut-
ting unit is switched off automatically and
the shredder switches to standby.
Note:
You can fold the safety
element upwards to
shred larger quantities
of paper. This makes
it easier to access the
feed opening.
Please consider the environment and dis-
pose of different materials separately.
Shredding credit cards
(only in cut size: 5.8 mm, 3.9 mm, 4.5x30 mm,
1.9x15 mm)
Feed the cards through the CD slot
when the cut size is 5.8 mm, 3.9 mm and
4.5x30 mm. For machines with a cutting
width of 1.9x15 mm, use the paper feed.
Switching off the shredder
• Press the operation button.
The “Ready for operation” indicator goes
out.
• Set mains switch at rear of paper shred-
der to „0“.
http://www.monomachines.com/
http://www.monomachines.com/
To Next Page
Loading...
Need help?
General
