To Next PageTo Next Page
Need help?Do you have a question about the HSP NTG-3000 and is the answer not in the manual?
Specifies temperature range and rate of change for storage.
Details mechanical strength requirements for stationary and transport conditions.
Describes the steps to install the device onto a mounting rail.
Outlines the procedure for removing the device from its mounting.
Illustrates the terminal connections for power, signals, Ethernet, and PROFIBUS.
Details the requirements for connecting the protective earth conductor.
Explains how to connect the 24V DC power supply.
Specifies requirements for connecting measuring input cables, including shielding.
Describes the Ethernet connection using an RJ-45 connector.
Details the PROFIBUS connection via a 9-pin D-Sub socket.
Explains how to use the rotary switch for device configuration.
Describes the Chebyshev filter used for analog inputs and its coefficients.
Details the scan rates for analog inputs in different modes.
Shows the block diagram for the filter structures.
Explains the mathematical algorithm for the second-order filter.
Mentions parameterization of first and second filter levels via Profibus.
Details fixed parameters for the third filter level (notch filter).
Describes the simple phase failure detection method and its limitations.
Explains the advanced phase failure detection algorithm and its operation.
Details the Rate-of-Change filter to prevent abrupt frequency changes.
Specifies how data is sent via Ethernet using UDP packets.
Explains how data is transmitted via PROFIBUS upon request.
Mentions where to find details on data transmission format.
Lists the meanings and colors of the status and error LEDs.
Provides solutions for common error descriptions indicated by LEDs.
Details changes made between software versions 3.7 and 3.8.
General| Brand | HSP |
|---|---|
| Model | NTG-3000 |
| Category | Transducer |
| Language | English |
