Need help?Do you have a question about the HT Italia GSC53N and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Model | GSC53N |
| Manufacturer | HT Italia |
| Type | Clamp Meter |
| Resistance Measurement | Yes |
| Frequency Measurement | Yes |
| Continuity Test | Yes |
| Diode Test | Yes |
| Display | LCD |
| DC Voltage | Up to 1000 V |
| DC Current | Up to 1000 A |
| Resistance | Up to 60 MΩ |
| Current Measurement | AC/DC |
| Voltage Measurement | AC/DC |
Recommendations and warnings for safe operation and accurate measurements during use.
Procedure for continuity tests with 200mA current and different modes.
Steps for measuring insulation resistance using various DC test voltages.
Instructions for testing RCD tripping times, currents, and contact voltages.
Procedures for measuring line and fault loop impedance and calculating short-circuit current.
Methods for measuring earth resistance and ground resistivity using earth rods.
Performing continuity tests with a higher 10A test current (GSC57 only).
Step-by-step guide for connecting and performing measurements in single-phase systems.
Procedure for measurements in three-phase, 4-wire systems, including clamp meter usage.
To Next Page
