Need help?Do you have a question about the HTP Invertig 201 AC/DC and is the answer not in the manual?
General| Input Voltage | 230V |
|---|---|
| Input Phase | Single Phase |
| Input Frequency | 50/60 Hz |
| Amperage Range | 5-200 A |
| Duty Cycle | 60% @ 200A |
| Welding Processes | TIG, Stick |
| AC Frequency | 20-250 Hz |
| AC Balance | 30-70% |
| Type | TIG/Stick |
| Cooling System | Fan Cooled |
Lists specific items and conditions not covered by the manufacturer's warranty, such as consumable items and unauthorized repairs.
Indicates when the unit is correctly connected to AC power and the On-Off switch is in the 'On' position.
Illuminates when welding current is applied to the torch or, in stick mode, is always on.
Lights up when the machine overheats, indicating it will not weld until it cools down.
Multi-function display that shows welding voltage during operation and other parameters when buttons are pressed.
Multi-function display that shows welding amperage during operation and other parameters when buttons are pressed.
Activates or deactivates the AC welding mode, indicated by a green 'AC ON' light.
Allows selection between Stick, TIG 2T, TIG 4T, and TIG SPOT welding modes.
Determines the welding amperage, adjustable from 5 to 200 amps, displayed when remote is off.
Adjusts the slope down time for TIG modes or spot welding time for TIG SPOT mode.
Adjusts the final current for TIG 4T, PROGRAM, or pulse modes, from 10% to 90% of base current.
Adjusts the post-gas flow time, essential for preventing weld defects and protecting tungsten.
Activates pulse mode, allowing adjustment of duty cycle and frequency for specialized welding.
Adjusts the AC frequency from 20 Hz to 200 Hz to control arc characteristics and bead width.
Activates remote amperage control via foot pedal or torch, allowing amperage limiting.
Adjusts the balance of the AC wave, affecting penetration and cleaning action.
Connects the gas fitting from the TIG Torch.
Connects the TIG Torch or electrode holder for DCEN stick welding.
Used for TIG torches with on/off triggers; not typically used with this machine's standard setup.
Connects the ground cable or electrode holder for DCEP stick welding.
Connects the footpedal for amperage control.
Controls the main input power to the Invertig Welder.
Step-by-step guide for connecting the water cooler to the TIG torch and the welding machine.
Describes standard Pyrex Cup Kits and their benefits for TIG welding.
Details special large diameter Pyrex Cup Kits designed for welding titanium.
To Next Page
