| 15
8-Channel Transmitter HT8S
2. TRANSMITTER SETTINGS:
The device has six selectable modes of operation (factory setting 0) which are
programmed when the battery is put in. To change the default settings continue
with the following steps:
1. Take the battery out the battery holder.
2. Press any key for one second to discharge the buffer capacitor in the device
and erase previous settings.
3. Select a mode: hold down the appropriate key (1-5) and insert the battery
into the device. If no key is pressed when inserting the battery factory settings
(mode 0) will be installed.
4. Release the button.
THE FOLLOWING PREPROGRAMMED MODES ARE AVAILABLE:
1. MODE 0: Factory presets. The factory presets are installed
when no key is pressed in the battery is inserted
into the device:
1.1 Operating frequency: 868.35 MHz
1.2 Transmission: Continuous operation. The transmission lasts as long
as the button is pressed.
2. MODE 1: Mode that is installed when button “1” is pressed
when inserting the battery:
2.1 Operating frequency: 869.05 MHz
2.2 Transmission: Continuous operation. The transmission lasts as
long as the button is pressed.
3. MODE 2: Mode that is installed when button “2” is pressed
when inserting the battery:
3.1 Operating frequency: 869.55 MHz
3.2 Transmission: Continuous operation. The transmission lasts as long
as the button is pressed
To Next Page
Loading...