Installing the display
To avoid damaging the screen, do not press on the screen when taking the display panel
out of the packaging.
1 Place the display panel on a clean and at surface, with the front side facing down. (You
can view device information including the S/N code on the nameplate on the rear side of
the display panel.)
2 Use screws to connect the base to the support.
3 Tilt and insert the upper end of the base support into the slot at the rear of the display,
and then press the base support downwards until you hear a clicking sound, which
indicates that the base support has been installed correctly.
To remove the base,
nd the button above the port at the rear of the display, push the
button upwards, lift the bottom of the base support, and remove the base.
3
To Next Page
Loading...
Need help?
General
