Huawei AR1200 Series - Logging In to the System for the First Time

Compliance and Safety Manual 2 Regulatory Compliance Information
Issue (2009-08-24) Huawei Technologies Proprietary 2-7
2.2 European Directives Compliance
AR1200/AR2200/AR3200 Series Products comply with the following European directives.
l
89/336/EC (EMC)
l
2006/95/EC (low voltage)
l
1999/5/EC (R&TTE)
Refer to Figure 1-1 for Huawei Declaration of Conformity.
AR1200/AR2200/AR3200 Series Products comply with Directive 2002/95/EC, on the RoHS
in electrical and electronic equipment. The device does not contain lead, mercury, cadmium,
and hexavalent chromium and brominated flame retardants (polybrominated biphenyls (PBB)
or polybrominated diphenyl ethers (PBDE)) except for those exempted applications allowed
by RoHS directive for technical reasons.
AR1200/AR2200/AR3200 Series Products comply with Directive 2002/96/EC on waste
electrical and electronic equipment. Huawei is responsible for recycling its end-of-life devices.
Contact Huawei local service center when recycling is required.
The main materials in the device are steel, plastics, copper, and electronic components. Most
of the materials are recyclable.
lists the main materials used in the device.
Comply with the following rules for recycling at the end of life of the device.
l
Remove power first in the disassembly.
l
Remove and send battery、PCB、fans and cables to special institution for disposal
because it contains chemical substance.
l
Dispose of battery separately because it contains hazardous substance.
l
No hazardous substance is contained in the label printing ink and plastic paint, and no
hazardous gas is emitted when the label printing ink and plastic paint is burning.
l
Dispose of the yellow chromate conversion coating screw separately because it contains
Cr
6+
.
l
Provide the plastic marking reference, such as ISO1043, and EN50419.
2.3 USA Regulatory Compliance
2.3.1 FCC Part 15
AR1200/AR2200/AR3200 Series Products comply with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
l
This device does not cause harmful interference.
l
This device must accept any interference received, including interference that may cause
undesired operation.