10
Use a RS232 cable to connect a PC to the RS232 interface of the router.
1
Start the terminal simulation software, create a connection, specify the connected port, and set
communication parameters as follows:
2
NOTE
If your PC's operating system provides terminal simulation software (like HyperTerminal in Windows 2000), you do
not need to install additional terminal simulation software. If the PC runs on an operating system without terminal
simulation software (like Windows 7), install third-party terminal simulation software on the PC by referring to user
manual or online help.
A PC may have more than one serial port. Select the port to which the RS232 cable is connected. Generally, COM1 is
used. If you modify the serial port communication parameters on the router, modify the communication parameters
on the PC to ensure that they use the same communication parameters, and then set up the connection again.
Bits per second (B): 9600
Data bits (D): 8
Parity (P): None
Stop bits (S): 1
Flow control (F): None
If you forget the login password, restore the password according to the Troubleshooting.
After successful login, you can now use commands to configure router. For more information, see the CLI-based
Configuration.
WARNING
NOTE
The default user name is admin and the default password is Admin@huawei.
Press Enter until a message is displayed asking you to enter the username and password. (The following
information is for reference only.)
3
Login authentication
Username:admin
Password:
<Huawei>
Info: The entered password is the same as the default. You are advised to change
it to ensure security.
8 Logging In to the Router
To Next Page
Loading...
