Table 3-423 GE electrical interface attributes
Attribute Description
Connector type RJ45
Standards compliance IEEE802.3, IEEE802.3u, IEEE802.3ab
Interface attribute MDI/MDIX
NOTE
l MDI stands for medium dependent interface,
an Ethernet interface connection mode.
Ethernet interfaces of most network interface
cards (NICs) are MDI interfaces.
l MDIX stands for medium dependent
interface crossover, a version of MDI. MDIX
interfaces are usually used on hubs or LAN
switches.
Frame format Ethernet_II, Ethernet_SAP, Ethernet_SNAP
Network protocol IP
Cable type 6.6 Ethernet Cable
GE optical interface
A GE optical interface (100/1000 Mbit/s auto-sensing) transmits and receives service traffic at
100 Mbit/s or 1000 Mbit/s. It uses optical fibers together with a GE or FE optical module.
Table 3-424 lists GE optical interface attributes.
Table 3-424 GE optical interface attributes
Attribute
Description
Connector type LC/PC
Interface attribute Depends on the optical module used
Standards compliance IEEE802.3ab
Frame format Ethernet_II, Ethernet_SAP, Ethernet_SNAP
Network protocol IP
10GE optical interface
A 10GE optical interface supports GE/10GE auto-sensing and can send and receive data at 1
Gbit/s or 10 Gbit/s. Table 3-425 describes the attributes of a 10GE optical interface.
Huawei
AR500&AR510&AR531&AR550&1500&AR2500
Industrial Switch Routers
Hardware Description
3 Chassis
Issue 10 (2019-03-06) Copyright © Huawei Technologies Co., Ltd. 523
To Next Page
Loading...
