22
y Preamble Type: It has two options: Long and Short. In the case that the client
(PC) supports the Short type, the WLAN can have a better performance if it is
Short.
y MAX Associations Limit: It refers to the maximum number of connections. It is
used to set the maximum number of concurrent WLAN users on the device.
y Mode: It refers to the WLAN accessing mode. The device can work in two modes,
as shown in the following table. The default value is Access Point.
Mode Description
Wireless
Bridge
It is used to connect two or more access points.
Access Point The access points meeting the IEEE 802.11b/g standard or the
wireless terminals can connect the wireless device.
y Bridge Restriction: It refers to the limitation to the peer MAC addresses. When it
is Disabled, the device can access all the remote bridges; when it is Enabled,
the device can only access the remote bridges that the addresses are in the
address list.
y Bridges: It refers to the physical address of the remote peer bridge. The device
supports the point-to-multipoint (PTM) bridge mode.
y Peer MAC Address: It refers to the physical address list of the remote peer
bridges..
y Link Status: Up shows the successful connection and Down shows the failed
connection.
To Next Page
Loading...
