Huawei E5776s User Manual

Configure a Huawei router to connect to the Internet using GigSky - 1
Configure a Huawei router to connect to the Internet using GigSky
The Huawei E5776s Wi-Fi router purchased from GigSky is pre-configured with the correct APN
(Access Point Name) setting of gigsky, which enables it to connect to the Internet correctly.
Sometimes, when moving between countries, the APN will be reset to the factory default. When
this happens, the router will not connect properly, and you will either get no data, or you may see a
web page prompting you to set the APN on your computer or mobile device. If you experience
either of these conditions, then you will need to select the correct APN on the router. To do this,
carry out the following steps:
Connect to the router's Wi-Fi network
Connect to the router’s Wi-Fi network using your computer, tablet or smartphone.
Note: The default Service Set IDentifier (SSID) and wireless network encryption key are engraved
into the bottom of the device.
Connect to the router's admin interface
1. Open http://192.168.1.1 in your web browser
2. Click the “Log In” link: Username - admin, Password - admin
Note: If the device determines that your password is too weak, it will prompt to change the
password. You can choose to ignore this prompt.

Huawei E5776s Specifications

General

Model	E5776s
Category	Wireless Router
LTE Category	Category 4
Max Download Speed	150 Mbps
Max Upload Speed	50 Mbps
Wi-Fi Standard	802.11 a/b/g/n
Wi-Fi Frequency	2.4 GHz
Max Wi-Fi Users	10
Battery Capacity	3000 mAh
Dimensions	106.4 x 66 x 15.5 mm
Weight	150 g
External Ports	Micro USB
SIM Card Type	Standard SIM
Device Type	Mobile Wi-Fi
Network Technology	LTE
Operating Time	10 hours
Standby Time	500 hours

Summary

Connect to Router Wi-Fi and Admin Interface

Connect to Router's Wi-Fi Network

Connect your computer, tablet, or smartphone to the router's Wi-Fi network.

Access Router Admin Interface

Open http://192.168.1.1 in a web browser and log in with default credentials.

Check and Configure APN Settings

Navigate to Profile Management

Access the 'Profile Management' section via 'Settings' in the admin interface.

Verify or Create GigSky Profile

Check if 'GigSky' profile exists; if not, create it.

Enter APN Profile Details

Set Profile name to 'GigSky', APN to 'gigsky', and APN type to 'Static'.

Verify Network and Mobile Settings

Ensure GigSky is Default Profile

Confirm that the 'GigSky' profile is selected as the default.

Set Network Modes to Auto

Configure Network and Network Search modes to 'Auto'.

Configure Mobile Connection

Set Connection mode to 'Auto' and enable 'Data roaming'.

Reboot and Verify Connection

Reboot the Device

Access the 'Reboot' option under 'System' and click the 'Reboot' button.

Verify Internet Connection

Check the admin interface or LCD screen for a successful internet connection status.