HUAWEI
5
4 Getting Started
Laptop Configuration Requirements
To use the Data Card, the following are required for your laptop:
l A type II PCMCIA Card slot supporting CARDBUS.
l A 133 MHZ Pentium processor or above. 500 MHz Pentium or the
microprocessor with higher frequency is recommended.
l 32 MB RAM or above. The memory of 128 MB or above is
recommended.
l 30 MB idle hard disk or above.
l Windows XP or Windows 2000 operating system.
l Display resolution of 800 % 600 pixels or above. Display resolution of
1024 % 768 pixels is recommended.
Preparing the Data Card
1. Take out the HUAWEI 3G Data Card from the protective cover.
2. As shown in the following figure, insert the SIM/USIM card into the slot
on the back of the Data Card, and make sure the golden contact on the card is
facing downwards.
To Next Page
Loading...