Mounting an ONT onto a Wall
1. Mark two positions with the same spacing as that between the two mounting holes of the
ONT using a marker on a wall.
2. Select a proper drill bit according to the outer diameter of the screws. Use a hammer drill
to drill the marked positions on the wall. Then clean the holes and install two expansion
bolts.
3. Use a screwdriver to fasten the screws into the expansion bolts, reserving 5 mm ends out
of the wall, and mount the ONT onto the screws.
NOTE
It is recommended that the screw be about 4 mm in diameter and longer than 20 mm.
EG8143A5
Quick Start
1 Placing the Device
Issue 02 (2019-09-10) Copyright © Huawei Technologies Co., Ltd. 2
To Next Page
Loading...
