11
RST Button
7.5
Operation Function
Hold down the
button for 1s to
3s.
When WLAN is set to OFF in idle state, hold down the RST button for 1s to
3s to power on the WLAN module. The alarm/maintenance indicator (ALM)
then blinks green fast for 2 minutes (other indicators are off) and the
SmartLogger waits for connecting to the app. If the app fails to be connected,
the WLAN module is automatically powered off after it is powered on for 4
hours.
Hold down the
button for more
than 60s.
Within 3 minutes after the SmartLogger is powered on, hold down the RST
button for more than 60s until all indicators are off and then wait until the
RUN indicator is on. The SmartLogger restarts and restores to its factory
settings.
To Next Page
Loading...
