10
5. On the Deployment Wizard page, set parameters as prompted. For details, see Help
on the page.
During parameter settings, click Previous, Next, or Skip as required.
6. After the parameters are configured, click Finish.
FAQs
7
1. Check the RS485 communications cable and AC power cable connection. If any cable is loose,
disconnected, or reversely connected, rectify the connection.
2. Check the RS485 communications parameter settings. Ensure that the baud rate and
communication address are set correctly and that the device address is within the search
address range of the SmartLogger.
3. Check whether the devices that do not support automatic identification, such as the EMI and
power meter, have been manually added.
4. Check whether the devices connected to the SmartLogger are powered on.
The SmartLogger Cannot Find Devices
7.1
The 4G Communication Is Abnormal
7.2
1. Check whether the SIM card is properly installed.
2. Check whether the SIM card is damaged or in arrears.
3. Check whether the 4G antenna is loosely connected or damaged.
4. Check whether the management system parameters and wireless network parameters are
set correctly.
The SmartLogger Cannot Communicate with the Management System
7.3
1. If a wired network is used, check whether the WAN port or SFP port of the SmartLogger is
connected correctly.
2. If a wireless network is used, check whether the SIM card and antenna are installed correctly.
3. Check whether the parameters of the wired or wireless network are set correctly.
4. Check whether the management system parameters are set correctly.
How Do I Set Export Limitation Parameters
7.4
1. Log in to the WebUI, and choose Settings > Power Adjustment > Export Limitation.
2. Set corresponding parameters as prompted. For details, see Help on the page.
To Next Page
Loading...
