4
3 Connect and power on the power adapter.
Connect the power adapter to the CPE and the power supply.
Power on the power adapter.
The CPE will automatically power on and search for available mobile networks. If the indicator status is lit up in
any of the following ways, it indicates that the CPE has successfully connected to the network.
5G/4G signal indicator Steady on Green/Yellow/Red Signal strength: Strong/Medium/Weak
4 Determine the installation position based on the detected signal strength.
Test the signal strength at different locations using a phone or PC. Perform the corresponding steps based on the
device you use.
For Android phones, see section 4.1 Test the signal strength with an Android phone.
For iPhones/PCs, see section 4.2 Test the signal strength with an iPhone/PC.
LAN
WAN&
POWER
LAN
WAN&
POWER
Reset
Reset
LAN
WAN&
POWER
Reset
To Next Page
Loading...
