1. To use this function, go to More > Timer on your band screen.
2. Setting the Timer
– When using the Timer function for the first time, access the Timer settings screen of
your band, and set the hours, minutes, and seconds. The value range for hours is
0–11, while that of minutes and seconds is 0–59.
– If you have used the Timer function before, open the Timer screen you accessed last
time and touch , and set the hours, minutes, and seconds.
3. Touch to start the Timer.
4. Touch to pause the timing, and touch to end it.
5. Your band will vibrate and its screen will switch on to notify you when the set time has
been reached. Swipe right on the screen or touch
to turn off the Timer.
Perform no operations and Timer will automatically close after 1 minute.
NOTE
When Timer is enabled, the on-going timing screen will display when you return to it again from the
home screen.
2.6 Stopwatch
To use the Stopwatch function on your band, perform the following steps:
1. Go to More > Stopwatch on your band screen.
2. Touch
to start timing. The maximum display time for Stopwatch on your
band is "59:59.9". The band screen will remain on while it is running.
3. While Stopwatch is running, you are able to:
– Touch
to stop the timing.
– Touch to continue taking time.
– Touch
to end timing and reset Stopwatch at "00:00.00".
– For the HONOR Band 4: Swipe right on the screen and will pop up, touch
to continue the timing, and touch to exit and return to the previous
screen.
– For the HONOR Band 5: Swipe right on the screen to return to the More screen,
and the timing will not end.
HONOR Band 4&5
Online Help (01,en-us)
2 Basic operations
Issue 01 (2019-09-06) Copyright © Huawei Technologies Co., Ltd. 18
To Next Page
Loading...
Need help?
General
