Huawei IPC6325-WD-VF - Indoor Ceiling-Mount Installation

Place the ceiling-mount bracket to the required installation location,
use a marker to mark the screw installation positions and drill holes in
the marked positions.
将吊装支架放置于安装位置，使用记号笔绘制螺钉安装位置，并根据绘制的螺
钉安装位置钻孔。
Install the Device/ 设备安装
2
5
1
4
Use a Phillips screwdriver to remove the transparent cover.
使用十字螺丝刀将透明罩卸下。
Align the tapped holes of the camera with installation slots on the
ceiling-mount bracket plate, thread screws through the holes, and
tighten the screws.
将摄像机的安装螺孔对准吊装支架安装盘上的对应安装槽，将螺钉穿过螺孔，
拧紧螺母。
C Indoor Ceiling-Mount/ 室内吊装
Use a claw hammer to install the expansion bolts into the holes.
使用羊角锤将膨胀螺栓打入钻好的孔内。
NOTE/ 说明
For details about subsequent installation
operations, see steps 4 and 5 in B Surface-
Mount.
后续安装的具体过程请参见“B 吸顶安装”中的
4-5步骤。
3
Remove flat washers, spring washers, and nuts from the expansion
bolts. Thread the cables through the ceiling-mount bracket. Put the
four expansion bolts through the four screw holes at the bottom of the
ceiling-mount bracket, put the flat washers, spring washers, and nuts
on the expansion bolts, and tighten the nuts.
拧下膨胀螺栓上的平垫、弹垫和螺母。将需要与摄像机尾线对接的线缆穿过吊
装支架。将吊装支架底座上的 4 个螺孔套在相应的膨胀螺栓上，将平垫、弹
垫和螺母套在膨胀螺栓上，拧紧螺母。
6
Align the tapped holes on the edge of the ceiling-mount bracket
plate with the tapped holes on the installation bowl, and use a Phillips
screwdriver to tighten the screws.
将安装盘边上的螺孔对准安装碗的四个螺孔，使用十字螺丝刀拧紧螺钉。