Huawei OceanStor 5800 V3 - Connecting Ground Cables; Connecting Ground Cables in a DC Scenario; Connecting Ground Cable for High-Density Disk Enclosure in AC Scenario

14
2h
(Optional) Installing filler panels
2g
(Optional) Installing disk modules
In addition to the empty space of the cabinet, you must install filler panels for the cable tray of the controller
enclosure. The following figure shows how to install a filler panel. If the cabinet is equipped with filler panels,
skip this procedure.
(1) Installing disk modules into a 2 U disk enclosure
Scenario 1 Installing disk modules into a disk enclosure
(2) Installing disk modules into a 4 U disk enclosure
(1) (2)
Scenario 2 Installing disk modules into a high-density disk enclosure
To ensure well heat dissipation, insert disks in the sequence of disk slot IDs. If there is any vacant disk
slot, cover it with a filler panel.
NOTICE
To ensure well heat dissipation, insert coffer disks to slots of A0 to A3. Then insert disks from left to right
and from E0 to A14. If the disk module is not fully configured, cover filler panels over vacant disk slots.
NOTICE