27
5 Installing Boards
Installing Cross-Connect Boards or Service Boards in Cross-Connect Board Slots
b
Turn the ejector levers outwards and slide the board along the
guide rails. Push the ejector lever inwards.
Installing Boards in the Interface Area
c
When inserting a board, push it into the subrack completely and then apply a downward force on the upper
ejector lever. After the upper ejector lever is locked, press the lower part of the system board front panel to
ensure that the board is installed properly. Fasten the captive screws at last.
When removing a filler panel in the interface area, apply screw gently outward
to loosen the bolt completely. And then, remove the unit gently
To Next Page
Loading...
