OptiX RTN PI-DC B10
Product Overview and Quick Installation Guide
Safety Precautions
• The equipment that collect to the GE electrical port must have surge protection capabilities. If the equipment does not
have surge protection capabilities, the PIs should be installed indoors for surge protection and easy maintenance.
• Always hold an insulated part of the P&E cable. Never touch the RJ45 connector.
• Do not touch the pins inside the P&E port on the PI with your hands or a conductor.
• Be sure to connect the power cables of the PI correctly to the positive and negative terminals of the power supply
device .To prevent damage to power cables or devices caused by short-circuits, install a circuit breaker on the
negative terminal of the power supply device.
• Do not install or remove a live P&E cable.
Issue: 05
Date: 2018-10-30
Huawei Technologies Co., Ltd.
Address: Huawei Industrial Base
Bantian, Longgang
Shenzhen 518129
People's Republic of China
Website: http://www.huawei.com
Email: support@huawei.com
No part of this document may be reproduced or transmitted in any form or by any means without prior
written consent of Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd. 2018. All rights reserved.
01
HUAWEI TECHNOLOGIES CO., LTD .
To Next Page
Need help?
General
