1
CAUTION
ESD Protection
Always wear ESD gloves or an ESD wrist strap prior to contact with the equipment or before handling devices, boards, or IC chips
to prevent damage to sensitive components due to electrostatic discharge from the human body. Ensure that the ESD wrist strap is
properly grounded.
Safety Information
Always wear protective gloves when lifting or transporting a cabinet to prevent hand injuries or damage to the cabinet surface.
The equipment is heavy. To prevent human injuries or equipment damage, always use a lifting device to transport or position the
equipment. Use a pallet truck or heavy-duty bogie wagon to transport the equipment on even ground, and use a cargo lift to transport
the equipment between different floors. If the equipment room does not have a cargo lift, a stair-climbing truck is recommended to
transport the equipment between different floors.
CAUTION
This document provides guidelines for quick hardware installation. It describes procedures for onsite installation, but does
not describe pre-delivery assembly.
NOTE
Installation Precautions
ESD jacks on the T32 subrack
ESD jacks on the T64 subrack
CAUTION
In different subracks, the minimum distance (L) between the board ejector lever and the cabinet door must meet
the following requirements:
•8800 T64/T32/T16 subracks, 8800 Universal platform subrack (DC power supply): L ≥ 50mm.
•8800 Universal platform subrack (AC power supply): L ≥ 75 mm.
To Next Page
Loading...
