135
Attaching a Label to a Power Cable
a
Attaching a Label to a Signal Cable
b
Attach a label to a cable, 2 cm away from the connector.
If a cable is routed vertically, the label needs to face to the right. If a cable is routed horizontally, the label needs to
face downwards.
Engineering Labels
Identification plate
Cable
Attach the identification plate on top of the
cable when the cable is routed horizontally.
Attach the identification plate on
the right side of the cable when
the cable is routed vertically.
Identification plate
Cable
To:
B03 — -48V2
To:
B03 — -48V2
Fiber
Fold to the right
Label
Fold upwards
TO:
A03 - 33 - 33 - 33 -33
Fiber Fiber
NOTE
NOTE
1
Attaching Labels
To Next Page
Loading...
