32
MON SYS LINE
RS232-1 RS232-2
LAN
11
Installing CRPC Cables
Connected to
the ETH1 port
A
B
B
A
Network management
cable
Connect working and protection CRPC power cables to the power ports on the CRPC and run them
upward along the cable area on the right side panel to the power cable terminal blocks at the top of the
cabinet top.
Insert one end of a straight-through cable to the LAN port on the CRPC and the other end to the ETH1 or
ETH2 on the SEI2 board on the OptiX OSN 9560 subrack.
Reserve 2U (89 mm) of space above the CRPC for heat dissipation. Ensure that air vents for the subrack
are not blocked.
Phillips screwdriver
CRPC power cable
CRPC
OptiX OSN 9560
CRPC power
cable
Cable for
communication
between the
CRPC and the
subrack
NOTE
To Next Page
Loading...
