28
Appendix 2 Installing the CRPC Frame and CRPC Board
3. Routing Cables
30
28
Connect the working and protection power cables of the CRPC frame to the power ports of the frame. Route the
power cables along the cable routing area on the right side of the cabinet to the power cable terminal blocks in the
PDU at the top of the cabinet. Then tighten the screws.
Route the fibers of the CRPC board.
Power
cables
A
SCA
SCA
STA
T
ACT
PRO
G
SR
V
ETH EXT
ALM
O1
ALM
I1
ALM
I2
F&f
LAM
P1
LAM
P2
A
Hub
Connect one end of a straight-through network cable to the LAN port of the CRPC board and the other end to the
EXT port of the SCA board. If two CRPC boards are installed, connect the two boards using a hub.
To Next Page
Loading...
