Need help?Do you have a question about the Huawei OptiX RTN 905 2E and is the answer not in the manual?
General| Category | Transmitter |
|---|---|
| Frequency Band | 6 - 42 GHz |
| Modulation Scheme | Adaptive Modulation |
| Power Supply | -48 V DC |
| Channel Spacing | 3.5 MHz, 7 MHz, 14 MHz, 28 MHz, 56 MHz |
| Supported Interfaces | FE, GE, STM-1 |
Covers safety precautions for operations, personnel, and device integrity.
Mandatory use of ESD protection when handling circuit boards.
Identifies ports and indicators on the RTN 905 1E front panel.
Identifies ports and indicators on the RTN 905 2E front panel.
Identifies ports and indicators on the RTN 910A front panel.
Identifies ports and indicators on the RTN 950 front panel.
Identifies ports and indicators on the RTN 950A front panel.
Identifies ports and indicators on the RTN 980 front panel.
Details steps for casting a concrete pad and marking anchor points.
Describes installing expansion bolts and positioning the base with washers.
Explains adjusting base level and tightening bolts using a torque wrench.
Provides instructions for moving the cabinet onto the base using lifting lugs.
Describes how to secure the cabinet to the base using bolts.
Explains installing the RTN 900 in an APM30H cabinet with AC power.
Details connecting the DC input power cable to the TMC11H cabinet.
Step-by-step guide for installing batteries, including safety warnings.
Details connecting power cables to the installed batteries.
Procedure for checking the power-on status of AC and DC power equipment.
To Next Page
